Have tried building U-Boot with a few changes compared to the default ones using the STM32MP1 Android distribution.When changing the ssbl-trusted-fbemmc.img which contains the U-Boot binaries, the U-Boot start fails showing the following boot logs:/T...
I am an embedded Android developer working on eval board STM32MP157f-EV1 ,we started to design a custom hardware based on it .So I downloaded the st-android-11.0.0-2021-01-29 android soft , and flashed the board as mentionned on the wiki hwo to and...
stm32mp157a-dk1 board
Hi,I started getting above errors recently, when trying to connect to an Android device.Can you elaborate on these errors on BLE?0x08 Connection timeout0x3E Connection failed to be establishedHow can I overcome them?Thanks
Hi,I was following the instructions from the ST wiki (How to build kernel for Android) on how to build the android kernel, however, on the last step, when instructed to build the final android images (make -j) I get the following error:"Cannot extrac...
I am using starter image "en.st-android-10.0.0-2020-02-21-eval-sd-starter.tar.gz".CubeProgrammer gave me "Error: an error occurred while uploading data from the virtual partition 0xF1" . Below is full log:16:56:19 : USB speed : High Speed (480MBit/s)...
Hello,I am going through building the base Android Distro for use in the STM32MP1 Discovery board, when I go to call the disco i.e. lunch aosp_disco-eng I get the error listed in the question.When I call lunch aosp_eval-eng then I get no error and we...
Please refer to the release note for more information: STM32MP15 distribution for Android release note - v2.0.0
I am super new to this and I need guidance. Does anyone have experience with using Android Studio to build an app and then using Bluetooth or WiFi so the app can connect to a STM32 Eval board? Where would be a good place to start? I have found the "S...
Hi,I'm lead embedded engineer at some company. Our current tech stack is android board for GUI and networking connected to stm32f2 over uart, which controls our hardware.We're trying to give a shot to stm32mp1, which could be great way to reduce hard...