Interface and connectivity ICs

S2-LP CSMA/CA - Guidelines for clear channel assessment period T_CCA and T_Listen

Are there any design guidelines or rule of thumbs for the clear channel assessment period T_CCA and T_Listen? Which considerations should be taken into account for T_CCA and T_Listen? According to my knowledge, T_CCA should at least be greater than ...

S2-LP: I like to use it only with the battery, so the SMPS won't be used, what is the conection of the pin1, "vbatt" or gnd?

SPIRIT1 / how to add in ''STM32CubeMX (v5.0.0)'' the file: en.x-cube-subg1_firmware ?

Please, see attached file.Thanks in advance.

BlueNRG-1 software problem

Hello.My customer has problems while testing BlueNRG-1 IC:"I can not make a simultaneous connection with several slave devices with the library from the BlueNRG-1_2 DK 3.0.0 package.After connecting to the first device, an attempt to start a new sear...

Creating border router on iMX6 with SPSGRF-915 Sub-1GHz module

Posted on June 02, 2018 at 07:24My goal is to create SUB-1 GHz 6LOWPAN mesh network, that will interact with an edge/border router and eventually that edge/border router forward data to the internet. For mesh network, I found documentation and resou...

Zigbee Smart Energy 1.2a

I would like to know if it is possible to create a device compatible with Zigbee Smart Energy 1.2a standard from the STM32WB55xx devices. I have seen the library STRF4CE for Zigbee implementation but I am not sure if it works for this version of stan...

STWLC33 - IDE & Advices

Hi,i need to find the right IDE for programming STWLC33 in ISB042V1 Board. Is there any programming advice / code samples in the STM webworld?

I'm starting for a PLC (power line communication ) modem design for transmission over a power line that along his activity can pass from 500 Vac to 24 Vdc or to cold status in a mesh private network .

My question is to verify if the component ST8500 can satisfy what is described previously taking into account that when it has to work with line at 24 Vdc or when in cold status it can't detect any "zero crossing" .Thank you

Implementing sensor model with bluetooth mesh

I need to implement sensor network with bluetooth mesh having three nodes. Two nodes would be STEVAL-IDB007V1 boards and one of the node would be smartphone which is used to display sensor data from two nodes (STEVAL-IDb007V1) . It is required to col...

Options for power line communication evaluation boards

Dear STMicroelectronicsAs students electrical engineering , we are looking into creating a test setup for power line communication over 48V DC lines. What are our options? We don't have the time to create our own transceivers using the system on chip...