Ask questions and find answers on connectivity ICs, focusing on protocols and I2C challenges on STM32 Nucleo boards and BlueNRG products.
Hello,I'm trying to use the CSMA feature but got the same problem as herehttps://community.st.com/s/question/0D50X0000B28om0SQA/s2lp-trying-to-get-csmaca-working.I tried to use the S2-LP DK GUI with X-NUCLEO-S2868A2 with NUCLEO-L053R8 to directly con...
Connecting via USB-C with the battery disconnected everything works correctly. PD contract is negotiated, 20V is delivered and when I plug the battery in to the charger it begins charging. If the battery is already attached when USB is connected, no ...
I was looking at the BLE_Sync sample code, when I stumbled upon something I couldn't find documented. void DTB_Init(void) { /* Enable the peripheral clock of GPIO Port A */ RCC->AHBENR |= 1<<3; /* PA1 tx/rx req*/ GPIOA->MODER |= (2<<2);...
I am running the BlueNRG sample application but I added ret = aci_gap_start_general_discovery_proc(SCAN_P, SCAN_L, PUBLIC_ADDR, 1);so that I can scan for devices. Then I added the following code to the user_notify() method in the sample_service.c fil...
Good afternoon....I am looking at getting an STEVAL-STLKT01V1 for development using the BlueNRG. My questions are: I notice in the BOM, the BlueNRG-MS is used and is NRND. How much difference is this from the M0?Can I use the CubeMX IDE for develop...
Do we have any firmware upgrade for supporting the RSA keys greater than 2048 bit keys?
hi, I'm a student and im learning how to use the board B-L475E-IOT01A. i am working on a simple project. I managed to activate the HTS221 sensors and the output is shown on Putty.exe I would complicate it a little bit and show the results on the STM ...
Hello ST,Is there a way to remove existing LPN node from existing Mesh network and compare RSSI value. Best RegardsDeepak
