We are pleased to announce that STM32CubeProgrammer 2.19 is available What is new in 2.19: Support for the STM32WBA6xxx microcontrollers: Internal memory programmingOption byte/OTP programmingRDP regression with passwordSFI support Support for MCE N...
Hello.I'm using the TSSOP-20 package STM32G051. After attempting to write some optional bytes, the situation is completely ruined. no longer able connect debugger, Erasing flash, and changing optional bytes. 1. My custom board is configured as follow...
I am using the following command ./STM32_Programmer_CLI --connect port=/dev/cu.usbmodem103 P=none but I get the following error:Error: Activating device: KO. Please, verify the boot mode configuration and check the serial port configuration. Reset ...
I have detected a problem with the v2.15.0 (64 bits) when flashing a STM32L475 MCU.The message 'sector nnn does not exist' appears repeatdly when erasing sectors when flashing the device.This only happens with v2.15.0., and then the device last a lot...
I am trying to modify the NRST_MODE option byte for a STM32G030 MCU.I have changed the reset pin to GPIO using the GUI, but that is not very usefull for a production environment.The option byte in not available from the CLI. -> Please make it availab...
I have tested few of the stm boards like STM32F302R8 , STM NUCLEO f767zi .We connect the hardware to laptop and usb pass through on VMware allows it to detect on virtual com port of VDI.But when we try to access the stm hardware through stmcube progr...
Hello Everyone, II'm currently working with my Nucleo L073RZ board and so far my program built successfully but i cant upload it. Nonetheless, other programs are still able to run well on the board. I dont understand what i am doing wrong. I have rea...
Dear Jocelyn RICARD @Jocelyn RICARD,I am reaching out to request guidance on encrypting a private key with RHUK and storing it in the OTP area. Could you please provide me with any relevant references or guidance on this matter?Thank you for your tim...
I am trying to migrate from cubeProgrammer 2.15 to 2.16I am using same exact command with both versionsbin/STM32_Programmer_CLI.exe -c port=usb1 -w "rusefi.bin" 0x08000000 -v -swith 2.15 output isMemory Programming ... Opening and parsing file: rusef...
Hi :)Problem: STM32F030R8T6 device not found.ErrorMsg in CubeProgrammer: "No STM32 target found! If your product embeds Debug Authentication, please perform a discovery using Debug Authentication."ErrorMsg in CubeIde: "Error in initializing ST-LINK d...
