STM32CubeProgrammer v2.18.0 release information New features:• Added the support for the STM32U3 series– Internal memory programming– Option byte/OTP programming– Core register programming– Regression with password (close/open)– SFI support– Key wrap...
When running stm32_programmer_cli.exe -l the first run shows a valid SN and FW version.The 2nd and subsequent runs show corrupt SN and FW version.The STM programmer version is 2.13.This repeats on 2 new ST Link debuggers.This repeats on 2 different c...
Hello,In one of my boards I was planing to use CANBUS bootloader and STLink V3 with external canbus PHY to program MCU.I was unable to program it, I can see STlink V3 does try to do some TX on CANBUS pin, but where is no packet available that could b...
Hi ST, can you please look into this link STM32CubeProgrammer & STM32CubeMonitor support SEGGER's J-Linksand let us know which version of the cube programmer support jlink. A.Satt
Is it planned that in the future the cube programmer will also work with the j-link like the cubeIDE?
Hello, I am trying to regress from RDP2 on my STM32U585AII6. I have no problem doing this from the STM32CubeProgrammer GUI, but when I try using the STM32_Programmer_CLI software I get:.\STM32_Programmer_CLI.exe -c port=SWD mode=UR -unlockRDP2 0xHigh...
Processor STM32WLE4CThe latest STM32CubeProgrammer_CLI is not working, and it's not setting:WRP1A_STRTWRP1A_ENDWRP1B_STRTWRP1B_ENDIt looks like an error.The sequence of steps to reproduce the issue.1) In the microcontroller's memory, I have code that...
while I install the stm 32 cube programmer oin my computer during the installation processes the computer asks me to install a driver I click yes and I have the programmer installed on my computer like normal but when I go to usb to Seach for device...
When I was using the STM32CubeProgrammer software, I selected the USB connection development board, and directly reported the error: "Device is under read out protection! If you want to disable RDP please reconnect with Read Unprotect enabled." But t...
Good day!Having just acquired a disco stm32g031j6, I discovered that while my CubeProgrammer has no issues connecting to it, ST-LINK Utility doesn't like it - it hangs on Target/Settings for a while, shows S/N in the drop-down box but doesn't recogni...
STM32CubeProgrammerを使用してボードをConnectしようとしたがErrorが発生する。使用しているボードはSTM32F746です。STM32cubeideでプロジェクトをRunした後にDebugをしなかった後にこのような動作が発生するようになりました。ジャンパーピンは5Vlinkに接続しUSBにてPCと接続しています。対処法を教えていただきたいです。
