Discuss power management solutions. Ask questions and find answers on voltage configurations, short circuit protection, and programming.
Hi.We are students working on a hardware project. We are designing based on the STEVAL-ISB68WA design and would like to know the derivations which could aid in our design(the formula for calculating the capacitor and resistance values).Is there anywh...
I'm designing a board with an STM32F MCU and a PowerSO36 L6206 and I would like to use overcurrent as a feature: the motors connected to the board will be used to move across an axis and the occurance of overcurrent means the motor has reached the be...
Here are pictures of the component I'm looking for.This comes from a control board for a rear light (Led) from an Aston Martin DB9 - 2005.There are 4 on the board and one of them is burnt.I can not find this component in the trade and impossible to f...
We Keysight Technologies have your battery product, STM M4T28-BR12SH in our product: E7402A,E7405A (EMC analyzer).Now our customer ask for the SDS(MSDS) _Safety Data Sheet of these lithium cell battery.https://www.st.com/en/clocks-and-timers/m4t28-br...
Testing the LED1642GW using the X-NUCLEO-LED16A1 expansion board. I appear to have the communication working using the digital keys for LE on a GPIO output and a SPI interface. I can read and write the configuration register and write brightness valu...
Since I do not want to use MCSDK but embedd the motor control in my own firmware I would like to have a firmware example for EVALSTRDRIVE101. Unfortunately the firmware example from ST does not seem to be available at this link https://www.st.com/en/...
Hi ST community,we were unfortunate enough to get some magic smoke from an old Hitachi IDE hard drive. It was possible to identify that the 12V and GND rails are shorted together and it's because of a diode (at least it is labelled with a "D") which ...
The peak on the resistors is about 2V, and we are using 3 parallel 0.1ohm resistors -> causing the device not working and infinity retries.We made a lot of experiments but for now, without any success.Any suggestions?I didn't find the datasheet of Co...
We have a requirement of power line communication temperature data measurement by 7580 IC Nucleo board. Initially we found this is very supportive, but the same time we found the ST board programming is bit difficult. Hence, now we are using Arduino ...
