I am using STGIB30M60TS-L for my BLDC motor control. But when i am turning the motor ON , the current is increasing continuously resulting in overcurrent error. I am unable to find out where the error is present .How to find it out . I am using TSV9...
I tried to update the STEVAL-IP023 board with DFU using STM32CubeProgrammer, but the STM32CubeProgrammer hang during the procedure, see picture attached.The board is recognized ad DFU device but the procedure does not work.Any suggestion?Thanks
Hi Team.I'm trying to connect STEVAL-GMBL02V1 board with STSW-GMBL02V1 control application.The cursor icon becomes a standby animation, but I cannot connect.I connected using the following steps:supply 8V of power to the STEVAL-GMBL02V1 board.connect...
