Hi,I am designing 2.7kw boost converter for which I am using SCTW100N65G2AG MOSFET. In the datasheet it lacks information about switching times(like rise time fall time and delays) and max DV/DT the MOSFET can take before failing. I feel these data i...
When I simulated the spice model of this PMOS device in Virtuoso, the following error occurred. How can I modify this? Thanks!
How do i set the STUSB4700 so that it sources 12V 3A with the help of the GPIO pins (NO SOFTWARE)I read in the datasheet that there are several standard PDO configurations, selectable via GPIOs. But how? How do I say that i just want the PD controlle...
Posted on December 30, 2017 at 11:16I have a LED2001PHR based LED driver that is designed to drive a string of LEDs at 5.2V and 3A. When I apply power and the LEDs are connected, the LEDs flash for a fraction of a second and then go off telling me t...
I have this design using SPV1040 It uses SM102K06L solar panels, that have Vmpp = 3.35V, Impp = 0.406 A (Pmpp = 1.36W). The output must charge a 4.2 Li-Ion battery. At direct sunlight with one panel, I am measuring 0.39 A, and 1.81 V (voltage measure...
Hello,I am using a STNS01 in my circuit for the power management. The problem is when I only have a charged battery (4.1 v) connected to the BAT pin, it does not switch to the battery voltage. As if the chip is in shutdown mode (I do not know why, th...
Hello everyone,I'm working on a circuit for monitoring the bias voltage of a GM tube, which requires a high voltage of 100V. I am currently using a OA1NP22C op-amp configured as a unity-gain buffer to read the divided voltage. To minimize current con...
The datasheet (and eval board) for the STUSB4710 show the device paired to a buck converter using a >22V supply for this USB C power source IC. I would like to drive the 4710 with 14V (automotive application) and be able to still get the full range o...
Hello, I have an issue with the L6699. The controller initiates the start-up sequence but after a few pulses it stops permanently.I describe the application first:Vin=385VVout=39 to 60 VTransformer magnetization inductance Lm=127uHResonant tank induc...
I am using Viper27HD integrated circuit. RC snubber structure is not recommended for the diode in the secondary output on the datasheet and edesignsuite.Resonance occurs between the secondary leakage inductance of the transformer and the parasitic ca...
