Hi,I am writing a customized bootloader for STM32L072CZ (Cortex M0+) and I have an issue with performing the jumping from the bootloader to the application.My application is linked at certain address (0x800b000) and I want to jump to this address fro...
BOOT0 is high and the chip is reset. Using the following command:./STM32_Programmer_CLI -c port=/dev/ttyUSB0 -vb 3 -ob displi'm getting the following result: ------------------------------------------------------------------- ...
Hello all,I am using STM32L011K6_Nucleo Board for developing a smart application, now I making prototype with STM32L011 microcontroller and some other sensors. My doubt how should I program my prototype board? what are the connection do I have to lea...
I have been flashing ST with the Flash Loader Demo utility successfully for long time, directly to my PCB design. BOOT0 pin is high, everything around the STM32 is quite (no activity on peripherals connected). Reset properly connected to a Resistor w...