Ask questions and find answers on STM32 microprocessors and dedicated embedded software solutions, such as Yocto SDK, Qt, and OP-TEE.
Moved from MCUs section - STM32 is an MPU.Hi all,I'm developing a firmware for a custom board based on MP135 micro - baremetal solution.The board has a MMC memory (no SD card) to host both bootloader and storage area (Fat).I've added the FileX module...
I want to enable libgfortran on OpenSTLinux distribution package. Based on the information that i found on the internet I added the following lines to the local.conf IMAGE_FEATURES += "tools-sdk" FORTRAN = ",fortran" FORTRAN_forcevariable = ",fortra...
Hello, If I put my new machine conf and device tree in meta-st-stm32mp-addons I can compile device tree and my image without any error. But if I use my own layer meta-my-layer (in meta-st), machine config is used but I have this message : | make[2]: ...
HelloI am trying to debug M4 firmware on my custom STM32MP157C board.I have a reference operating system built with yocto on which this works correctly.I have to build system with a changed configuration and debugging of the same firmware is not work...
I recently purchased the STM32MP157F-EV1 board and would like to run a Qt application on it. However, I am unfamiliar with the setup process and would appreciate your guidance on how to get started from scratch.Could you please provide me with the ne...
I'm using the Yocto-based OpenSTLinux embedded software on a STM32MP25x and I don't understand which portion of the SRAM1/2 is free to use at runtime.Aside from the first 4kBytes of the SRAM1 reserved for OTP shadow, can the rest be fully used, or is...
Hello,I am struggling with improper color management for our display connected as LTDC. I prompt for drm state with cat /sys/kernel/debug/dri/0/stateI wonder why I get format=RG16 (that is true, we use RGB565 LTDC interface) and color-encoding=ITU-R...
Dear all, we use custom board with STM32MP1 SoC onboard. We use Yocto with OE, STM, Qt and custom layers for building target images. In our device we utilize 7-inch display connected by LVDS with RGB666 wiring. If I load bitmap image from U-boot, a...
Hi, is it possible to know which is the Yocto configuration (manifest release, DISTRO and MACHINE used, other configurations, etc) used to generate the Starter Package of a board?I think it could be a useful information for everyone. In fact I'm in a...
Hi Everyone I am new member of ST device, now I face problem regarding SPI communication on STM32MP157F-DK2 kit.I am using the latest zephyr RTOS version (which primarily supported STM32157C-DK2 kit).Problem:- The Master Out pin does not output the d...