Discuss power management solutions. Ask questions and find answers on voltage configurations, short circuit protection, and programming.
Dear All, I purchased the L9963e board for demonstration of the BMS systems. I installed the NI tools and opened the same and its opening. I am unable to make a communication. I installed the FTDI driver as mentioned in the user manual in windows ...
Hi there!I'm using the STM32G474E-EVAL to drive the STEVAL-IPM20B (eval board for the STGIB20M60TS-L). I'm running my motor (SM3L-084A) at 380V. Note, I've checked with the vendor about running the motor at higher voltage than quoted and there should...
Currently we are evaluating voltage mode feature of powerstep01Motor Parameters:Motor Phase Resistance: 8.4 ohmMotor Phase Inductance: 5.2 mHKe: 0.07392We have tested voltage mode by changing current from 0.5 to 1.1 A. Test report are attachedAlso In...
Hello Team, While going through datasheet, I noticed that there is no mention on what happens if we are trying to put RID for a write only register in MOSI frame. Will it cause any faults or does it work as expected?
Hi I am currently working on a project using stwlc38.I am using it in conjunction with a power management IC, MAX17330.The circuit is simple, VOUT and system power is connected and normally I use it to discharge the battery which is connected to MAX1...
Will be looking for a simple sequence to activate the Outputs of the L9026 Note:- INT0 and INT1 are used to activate the chipQuick Response will be greatly appreciated.Thanks,Krishna
Hi,When STWBC86 is operating fully independently without being interfaced with a host system, how can the GPIO be used to drive indicator LEDs to indicate charging status, fault etc? The datasheet shows how these can be programmed to inputs or output...
Does anyone know if the L9305 supports Daisy chain communication? 有人知道L9305是否支持菊花链通讯？
HI Sir,how do we define the switching frequency of the L7987the switching frequency range is between 250KHz and 1.5MHzlooks like if the switching frequency is set to 1.5MHz, the ripple appears to be much smaller, so can we set it to 1.5MHz under norm...
