About hu88

hu88 · 2024-12-02

I am trying to control BLDC motor with Steval IPM30 B and Nucleo L476RG as controller. In sensor less mode it is working fine but when I am using Hall Sensor it is not rotating at all and its showing speed feedback error at the starting only. How to ...

hu88 · 2024-10-14

We have to been trying to establish serial communication between our motor and controller. For that we are referring the document attached in the mail. We are using the mc workbench version 6.3.0 . When we connect and control motor from motor pilot ...

hu88 · 2024-08-30

How to enable Hardware Flow Control in STM32 Cube MX , because when I am trying to enable it - conflict with ADC1:IN6 . I want to enable Hardware flow control RS485. I have attached the screenshot of the issue being faced. This program is generated ...

hu88 · 2024-07-08

I am using STGIB30M60TS-L for my BLDC motor control. But when i am turning the motor ON , the current is increasing continuously resulting in overcurrent error. I am unable to find out where the error is present .How to find it out . I am using TSV9...

hu88 · 2024-12-19

Hey, sorry for the late reply. I checked and 5V is coming at the pin 4 of hall sensor connector, in the starting only I made that arrangement.Hall sensor signals are also 5V peak-to-peak square wave, so that is not the problem.I am using ST MC workbe...

hu88 · 2024-12-09

I tried to rotate the same motor using STEVAL Spin 3201 with same hall sensors setting. It is rotating very smooth even at low speed(because max voltage is 45 volts in ST spin3201, so max velocity I can reach is 600RPM, otherwise the max velocity of ...

hu88 · 2024-12-04

Yes I used Motor Hall Sensor profiler. Is there any starting issue. In sensor less control the operation is smooth. But in hall sensor as speed feedback the motor doesn't even rotate a single turn and speed feedback issue comes.I tries to tune it als...

hu88 · 2024-12-03

Thanks for the reply.Switch configuration is now clear and we are able to get hall sensor pulses. We have probed it in oscilloscope by rotating the motor manually and observed the pulses.But when I am trying to run motor it just don't rotate only. As...

hu88 · 2024-10-17

So every time do we have to establish a connection before sending any command,or after establishing connection once ,we can send multiple commands like motor start, motor stop,etcAlso we have gone through the document and it is unclear, if you have ...

User statistics

User Activity

Hall Sensor in Steval IPM 30B

Serial communication in MCSDK 6.3.0

Hardware Flow Control in CubeMx selection

BLDC Motor Control

Re: Hall Sensor in Steval IPM 30B

Re: Hall Sensor in Steval IPM 30B

Re: Hall Sensor in Steval IPM 30B

Re: Hall Sensor in Steval IPM 30B

Re: Serial communication in MCSDK 6.3.0