I'm trying to get STM32MP157F-EV1 board working with the STM32Cube ecosystem. I have successfully followed the getting started guide., STM32MP157x-EV1 Lets Start URL. I get to the last step in /Populate_the_target_and_boot_the_image, (Step 8), B...
Hi,I have a problem in running graphics/image in STM32MP1 custom board.I'm working with STM32MP1 custom board & trying to bring up ST7701 display.I couldnt see kmscube running instead of a white screen.modetest command shows proper colour bar as atta...
I need to use the tc358867 bridge in my project. However, the hardware uses the clock that comes from the DSI. The chip's operating cycle requires the clock that comes from the dsi to start working and be found on the i2c bus. I am unable to activate...
i have been trying to use the LTDC peripheral on the Linux kernel to use it on the ILI9340 / ILI9340 in 8 bit mode.i use this in the device tree: <dc { status = "okay"; port { #address-cells = <1>; #size-cells = <0>; ltdc_ep1_out: endpoi...
Hi,We are using stm32mp157c MCU/board and it has DSI output built-in. Now we want to add display port support via DSI to eDP bridge SN65DSI86. It seems that stm32 does not support Displayport output or it has never been done. At least the driver dw_m...
We are doing a custom board bring-up and currently trying to display video on our display device. We use CubeMx to generate the device trees for our project, we have configured the DSI PLL dividers to match our display device requirement. Snapshot of...
i have following yocto build configurationBuild Configuration:BB_VERSION = "1.42.0"BUILD_SYS = "x86_64-linux"NATIVELSBSTRING = "universal"TARGET_SYS = "arm-openstlinux_weston-linux-gnueabi"DISTRO = "openst...
Hi all,I have been trying to get DSI interface on a custom board using STM32MP1.The device tree exactly done as given here : LInk.I do have DK2 kit , which i probe I am able to see the signals at DSI PHY even if display is not connected.In case of my...
I am using MB1407C (stm32mp157x-DK2 extension board with touch-screen) connected to my custom board. When board is booting I am getting the "ST life.augmented" screen on the U-boot and black screen when kernels starts. Also I am getting the telnet co...
I was planning on using the STM32MP157A-DK2 to drive a three lane DSI display but the Microcontroller only supports two lanes..