Discuss power management solutions. Ask questions and find answers on voltage configurations, short circuit protection, and programming.
Hello, I am using the integrated circuit mentioned in the title, and I want to set it to debug mode (referred to as flash mode), but there is something called Vflash mentioned. I don’t understand what it means, and there is no explanation provided a...
Thank you for your help.The data sheet for Eas (single pulse avalanche energy) of VNLD5160-E states that it is 37mJ at Tj=150℃, but please tell me the Eas at Tj=25℃.If it has not been measured, how many times would it be calculated? Thank you in adva...
Hi, I am currently working with the VN9D5D20FN and RL78, successfully controlling 4 channels at a 100% duty cycle, achieving a 12V output. Now trying to read the current sense value for Channel 1 with OUTCFGR1 configured to 0x9FE0 and a rheostat loa...
Hi,I'm debugging a board with two STMP34 used to read voltage and current from L1 - L2 and L3 of a threephase system. The current signals comes from three different TA devices.The issue is: sometimes, reading a block of registers using the Metro_HAL_...
I'm getting a STEVAL-WLC99RX and STEVAL-WBCTX70 configured for some testing and put the WLC99RX in DC mode (5V ono Vout). I cannot figure out how to get it back into Rx mode.It feels a little bit like a chicken and egg situation. I need to be in DC m...
I had previously asked in case # 00204067, if the subject part STGF15H60DF was UL approved for isolation and I was told that is was approved under UL catigory QQQX2.E81734 per the requirements of UL 1557. I was linked to UL File # E81734 with a highl...
L9966 has one spi interface to work with MCU's, but I need to know how it is working an d I didn't find documentation about it. Can somebody tell me where to find it?
Hi,This is a over voltage diode from a uC programmer that I blew. Can anyone tell me the value? Thank you for the help,Rob
I found an aplication (ST Design Tip - DT0001), that suggests a way of controlling motor speed, using a PWM signal on the DIR input. Works fine for speed. Note: we are not using a micro as shown in the DT90001. We are using our design. And using P...
Hello, I am trying out a 220 V power measurement set up with 3 STPM34 evaluation boards. I need to use as less wires as possible, so I am using SPI with 3 different CS and 1 SYN pin. I am also trying to reduce component count by using only 1 CLK sour...
