Wireless Charging solution Wiki
This Topic is used for Wireless Charging solution 1.Mcu C drive code: GitHub - STMicroelectronics/STWirelessCharging-C-Drivers: Standard C platform-independent drivers for wireless charging ICs
Power management
Discuss power management solutions. Ask questions and find answers on voltage configurations, short circuit protection, and programming.
Forum Posts
HVLED805
Posted on January 06, 2012 at 10:09Hello,I want to execute my project with HVLED805 where input voltage is 176…264 V.Output voltage for LED equal 18 V, output current 0.45 A.Edesign proposed the transformer with widings: Primary – 145 turns, Aux...
STM3210E Eval Board Problem
Posted on March 05, 2012 at 16:38STM3210E eval board has a stm32103ZG MCU on it and this MCU resides in XL-density group. The problem is related with ST motor control workbench. It has no option to generate header files for XL density devices unde...
STM3210E-EVAL dual motor drive
Posted on February 08, 2012 at 15:30Hallo, is it possible to drive two motors with this eval board? I don't want to drive them simultaneously and independently but ''mutual exclusive'', i.e. I have one enable signal for every motor, while only one ...
STM32 FOC PMSM SDKv3.0 Timer initialisation
Posted on February 15, 2012 at 01:24Hi, I'm working with the PMSM firmware library V3.0 to make a motor control using the STM32F103C8T6 processor operating on my own board. I am working with the provided non-RTOS project which was originally configu...
STM32f4Discovery schematic source files
Posted on February 06, 2012 at 08:46Where I can find the schematics source files of the STM32f4discovery board ? #schematics
L6470: Overclocking?
Posted on January 24, 2012 at 08:01Hi We want to overclock the L6470 (10MHz instead of 8MHz at OSCIN) to increase maximum RPM. The resolution will be reduced, this is clear, but is there any other risk to do so? Regards Michael
L6470: Output resolution, no different between 1/128 and 1/32?
Posted on December 22, 2011 at 15:03HiWe have measured the output signals of the bridges in 1/128 and 1/32 step mode and we can’t see a different voltage resolution between these 2 modes (see attachment). We have used the “GoTo�-command for th...
L6470: connect Vreg and Vdd for 5V supply?
Posted on August 18, 2011 at 21:35L6470: connect Vreg and Vdd for 5V supply? #l6470 #l6470
viper25
Posted on November 08, 2011 at 11:01In my design iam using Viper25DTH. My o/p power is upto 6W i.e. 4.1V@1.5A. But whenevr i am ging 1W load, the voltage on VDD pin starts to oscillate between 4.5V to 15V and feedback voltage is upto 3.4v, it seems ...
BRAKE on STMotor control WORKBENCH 3.0 (ID211)
Posted on December 26, 2011 at 13:35Hello.When activating the brake option I get the following error. ''ID211 brake resistor switch off threshold voltage Higher Than over-threshold'' Dissipative brake checked and active high. Min rated voltage 18V ...
