Power management

Hi all, I am working on integrating battery gauge IC drivers. I am looking for nRF-sdk drivers of STC3117. Can anyone hep me with this? Thanks in advance, Nirupama.T

Power Consumption during the use of Bluetooth and ways to reduce it?

Is there any specs out there that details the power consumption during the use of bluetooth, like in run mode? and is there any to reduce it to save power without heavily affecting the performance of the device?

LED2001 LED DRIVER. I wonder if Schottky diode should be added in the circuit. Typical application circuit in the data sheet does not include the external diode. Is the diode built in the LED2001 chip?

Radiation test Reports for RHFL7913SCA-03V?

Where do I find Total Dose and Neutron test reports for RHFL7913SCA-03V? Can someone point me to the location so I can download them?  Thanks

STEVAL-ESC001V1 Current Control

Is current or torque control possible on the  STEVAL-ESC001V1 ?

Hi How can I propose intellectual property (patent application) to your company? Area: Method and IC design for LED current balancing Thanks Oleksij Khyzhniak

STEVAL-POE001 not engaging when connected to 802.3AT PSE

I purchased a STEVAL-POE001 evaluation board for testing. Connected the board to several PSE units including an injector and a switch that supports 802.3AT. The board and the PSE LEDs flash momentarily but will not fully engage. I do not have any...

Port SPN3 motor-control examples to DK2?

We are considering using a combination of the stm32mp157 and several powerSTEP01 devices in a system with multiple stepper-motors.The X-NUCLEO-IHM03A1 plugs into the -DK2 just fine, but the SPN3 examples only work on the F0xx, F3xx, F4xx, and L0xx se...

Testing VN5010AK-E, need confirmation that I got the datasheet info right.

Hello to all,I found this new IC and want to test it for a while, but don't want to fry it before that :D, so just a several questions, where I doubt that I understood the datasheet correctly. There will be no uC, so I don't need current sensing, so...

Using the VNHD7012AY development board to run a brushed 12V motor, I have trouble at initial startup trouble that appears to be a problem with the fault circuitry.

Picture #2: (Current waveform) Operation with resistance added to OUT linePicture #1: (current waveform) Picture when motor does not start Regardless of what values I install for gate resistors (0, 475, 1100 ohm), Vref resistors (8-40K) adding ext fi...