Power management

STEF05: What is the minimum time En/Fault must be held low to reset the device?

I have a line of BLDC external rotor motors, rated 12vdc, 12pole, 3phase with 3hall sensors. I would like to purchase an evaluation driver board to test comparative performance for these motors. Any suggestions as to which driver to purchase?

Hello, Is it Ok to use VNH5180A-E Vcc power value 30V (Abs max is 41V and Op supply voltage max is 18V) ?

VNH5180A-E

Hello, I want to drive two BLDC motor by 6 step pattern. A 48V battery will be chosen for the power source. The motor driver should be able to supply 400 Watt power. Any suggestion on develop board/tools for this requirement? Thanks, Wayne

What is the maximum switching frequency of PWD13F60?

STEF05: What is the max current flow through R-Limit?

MOSFET parameters for SCT10N120

I am using SCT10N120 MOSFET in my design, Can I get the following parameters Cox - Oxide Capacitance W - Width of the deviceL - Length of the Channel I am trying to compute my drain current for a particular value of Vgs Thanks & Regards,Sakthivel 

hi, I need the .step and .dwg for part STGIF7CH60TS-L

hi, I need the .step and .dwg for part STGIF7CH60TS-Lemail: dxprodutos@gmail.com

For POWERSTEP01, (in Voltage Mode) does BEMF Compensation work when in External Step mode?

Does the chip measure time between microsteps to properly compensate BEMF when in voltage mode?

LM317T vs LM317BT

What is the difference between LM317T & LM317BT?