Discuss power management solutions. Ask questions and find answers on voltage configurations, short circuit protection, and programming.
I am looking for programmable buck converter to provide up to 12V/2A output with 24VDC input to use it in my design when I ran into STPD01. Could it be possible to use this buck to power up my circuit (not for USB purpose) ?Thanks!Sabrine
Hello,I am trying connect +4 LED1202 Driver in Daisy chain common clock domain configuration.(Refereing to LED1202 Datasheet Revision 2, DS12875 - Rev 2 )Under Section "6.2 Cascading multiple devices" and "Figure 23 Concept of daisy chain common cloc...
Hi,When searching "L78M12", there are two results in ST web site. One says that "L78M12AB" is obsolete. The other one says "L78M" is active. For both of them, there are links to datasheets. One datasheet is obsolete and the other one is active. I loo...
Hello. I'm Using L9369 for H-bridge control.I'm trying to set GIO0~8 pin high(Button interface), but i can't(Analog Output - SPI control)i'm using SPI command, and i saw L9369's manual and i follow the instruction below steps to set GIOx pin as high....
Hi, Can I learn MTBF value of "SCTW90N65G2V" MOSFET?or, How can I calculate?
HelloI couldn't find it on the official website of the product.I have download UM2270 document but couldn't get firmware source.Where can I get the source code described in the UM2270 document.Best Regards,J.P Hong
Can you share with me MTBF value of this product:L7805ACD2T-TR?
We’re moving the ST Community to a new platform to give you a better and more reliable community experience.
