Discuss power management solutions. Ask questions and find answers on voltage configurations, short circuit protection, and programming.
Hi all,Hoping this is this right subsection to post the following question...I'm reading the STPD01 datasheet and it states its available I2C addresses : 4, 5, 6, and 7.Reading to general I2C documentation, it seems that these addresses are reserved ...
KF50BD-TR The goods have a pin indicator,but it is not shown in the datasheet .Please check attached photos.Is the product with pin indicator original?
The STM6905 datasheet says in Table 2 that there is an internal 10k pull-up on RST#, which seems wrong since that's an open-drain output. Then in Section 2.6 and in Section 3 it says that an external pull-up to VCC should be used.
I am working on a LED driver design using the LED2000PUR and would like your expert review before I proceed further. Please find my schematic and design details in the attached PDF. Could anyone please confirm whether the design and component values ...
If I have only 5V input. what to do with the FB pin?
What does the appearance of KF50BD-TR look like ? Does it have pin 1 marker?Can you provide the relevant drawings?
Ciao, [English was established as the common basis so that everyone in the global community can understand each other (see ST Community Terms and Conditions - STMicroelectronics Community, article 10)] I recently purchased a new STEVAL-L99615C evalua...
I could able to find only .hex output file for this demo app. Where is the source code ?
Hello everyone,My apologies if this is in the wrong forum. I have a STEVAL-BMS114TX evaluation board and I'm wondering what to do with unmounted cells, since my pack is 5s. The datasheet for the L99BM114 says to short the unused PCB connectors togeth...
Hii everyone,I am designing AC-DC board using STNRG012 IC and used EVL012LED evaluation board for reference purpose and we are facing some isuess1. We design input voltage range from 90-305VAC.2. PFC boost voltage range would be 450V.so which par...
