ST25 NFC/RFID tags and readers

Resolved! Present sector password on M24LR64E-R with ios14

Hello,Im trying to read data from a M24LR64E-R tag with password.So, Im using customCommand() function with these data :flag : 0x0acommand : 0xB3payload : bytes from password This command works on Android but on ios I receive this error :[CoreNFC] 00...

Resolved! ST25DV16 - CRC16 Calculation for when the Error flag is set

Hi,I am receiving the wrong CRC16 value from the tag when it is answering error flags, for example:2020-12-16 14:01:18.143 writeMsg >> 02AA0200AA2020-12-16 14:01:18.148 writeMsg << 0F0F68EEI forced an error there (writing to the MB when it is off) an...

Resolved! ST25 NDEF messaging with Android

For data exchange between ST25DVxx with an Android smartphone we would like to use NDEF (NFC Data Exchange Format) messages. Will it work?  NOTE: This question and answer originated from a customer support case which was handled by us. We regularly r...

Resolved! Is X-Nucleo-NFC03A1 board compatible with Arduino Uno?

I have purchased "X-Nucleo-NFC03A1" NFC reader evaluation board. Can I use Arduino Uno to control the NFC board? and does anyone have a sample library?

Resolved! I'd like to porting example from STM32CubeExpansion_NFC6_V1.1.0 board STM32L476RG to board STM32WB55

I would appreciate any suggestions in that issue.Thank you in advance.Best regards.Piotr Olczyk

Resolved! Hi, I have a question about the picture ( i found it in the datasheet of LRI2K), but I didn't understand how you got 4.3uH for 28.5pF capacitor to have 13.8MHz. Normally we get 14.37MHz. Best regards,

Resolved! Is ST25RU3993 module support "Any Sensor tags " like RF micron ..?

Hi ,Is ST25RU3993 module support "Any Sensor tags " like RF micron ..?

Resolved! Hi there I am working with CR95HF-VMD5T 13.56 MHz transceiver and M24LR04E connected to STM32F1038T6 . How to save data reading by transceiver? Regards Hosein

Resolved! reading/writing N213 tags using rfal

Hi,How can I easily write/read N213 tags using rfal v2.2.0?For the v1.3.2 version I used to call rfalISO14443ATransceiveFrame() to do it but I don't know how it's done in this latest stack version.regards,gaston

Resolved! Low power mode ST25R95, power consumption?

Hello,I'm using ST25R95 in my project. I'm sending pulse signal in order to transit from powerUP mode, and after it the Idle command in order to enter hibernate mode.Idle command: {0x07, 0x0E, 0x08, 0x04, 0x00, 0x04, 0x00, 0x18, 0x00, 0x00, 0x00, 0x0...