Hello STMicroelectronics CommunityI am facing issues in configuration of ST25R100 chip with STM32C031C6T6 microcontroller in STM#@cube IDE. I am using default configuration settings but still facing trouble in initialization.Can anyone in here who is...
HiCan someone head me in the right direction to locate a very basic project to use a ST25 together with one of the HID chips or similar: Project for a tag only read direct into spreadsheet via HID. Thanks CharlesMicrochip’s ATtiny85 with V-U...
We developed custom PCB with CR95HF on it. PCB on itself was tested and RF circuit tuned(PCB and antenna design is based on development kit), antenna frequency is at 13.56MHz(+/- 0.5KHz), at around -60dB, uart communication working, can put CR95HF to...
Hi Team, Do you have any MCU/MPU that supports UHF RFID reader/writer?I see the ST25RU3993 was into this category, but becomes EoL. Do you have any replacement for the same? Regards,Jenitt
Hello everyone,A RF baudrate of 424 kbps with ISO/IEC 14443 Type A seems possible in the ST25R95 datasheet (page 15).I checked the SPI bus and this SPI frame is sent, as expected :controlcommandlength<Protocol><Parameters>... sendProtocolSelectlengt...
Hi,I have a question about configuring NDEF messages on tags.Can I put multiple function records in one NDEF file?For example, I just want to connect uri link with one NDEF file and also wifi connection at the same time.Is it possible? If possible, p...
Good Afternoon,I am currently trying to read a text file from an NFC tag from an ST25R3916-AQET NFC reader connected to an STM32 microcontroller.I have tried to make use of the example case offered by X-NUCLEO-NFC08A1 but it only shows how to detect ...
Hi,I have a c++ project using the ST25R95 as a reader talking to a STM32L4 micro. I want to play around with putting it in tag emulation mode so I can use an external reader to read data from it.I see references to emulation in the data sheet but do...
Hi,I have a new PCB design using the ST25R95 chip.The application : Communicate with a moving tag with a reader (ST25R95). The distance is fixed (5mm) and the tags move under the reader. The problem : there is a dead spot at that distance when the ta...
Hi,I need to prepare three modes for the certification testing.1) Always transmit modulated2) Always transmit unmodulated3) Always in receive mode.For no 1, I think I can just set the protocol as an example ISO14443 / ISO15693 then read tag, right?Bu...