About DGrgic

DGrgic · 2023-01-09

Hello,I'm using the NUCLEO-G474RE development board and trying to set the DBANK option byte. I can do that using STM32CubeProgrammer without any issues, and everything works as it should.But when I try to do that in the firmware using the HAL functi...

DGrgic · 2020-12-17

Hello,I'm using ST25R95 in my project. I'm sending pulse signal in order to transit from powerUP mode, and after it the Idle command in order to enter hibernate mode.Idle command: {0x07, 0x0E, 0x08, 0x04, 0x00, 0x04, 0x00, 0x18, 0x00, 0x00, 0x00, 0x0...

DGrgic · 2023-01-13

Amel thanks for your answer.Yes, I forgot to add return in that case indeed, but the thing is that I'm using a debugger, and I see there that HAL_FLASHEx_OBProgram returns HAL_OK and continues where it should go.It seems that I'm missing some steps b...

DGrgic · 2020-12-19

Hello @Brian TIDAL_O ,Thank you for your response. After we send the Idle command, the IRQ_OUT pin remains in a HIGH state, so we don't try to read the response with SPI.If the device is sent in hibernate mode, using the Idle command is it supposed ...

User statistics

User Activity

Problem with writing the DBANK option byte on STM32G474RE

Low power mode ST25R95, power consumption?

Re: Problem with writing the DBANK option byte on STM32G474RE

Re: Low power mode ST25R95, power consumption?