Hey,I have been using the x-cube-nfc3 demo for Nucleo-l496ZG 144 pin board along with a CR95HF. In SPI mode I can successfully initialise and read the ID from NFC tags. I attempted to change to UART mode by adding #define ST25R95_INTERFACE_UART 1to p...
I'm doing something very similar, and using the steval-smartag1 as a jumping off point. I'd like to be able to use the UART as a second SPI device, but I'm concerned that doing that would interfere with the debug interface.On a related subject, can t...
I am trying to get the demostration firmware to output some logs through UART or USART but was not able to do so.Both USB cables are connected (micro and mini) and I used Putty to connect to the Mini USB interface (ST link USB port). I also put the b...
I have the X-NUCLEO-NFC03A1 expansion board connected to the NUCLEO-F401RE, successfully running the demo polling code from X-CUBE-NFC3. I would like to modify the code to allow the two boards to communicate using UART alone (no SPI pins necessary). ...
Hello all,I will start by saying that I am new to STM32 development and that your patience is very appreciated for what I hope is a simple problem.I am working with a X-NUCLEO-NFC05A1 mounted on a NUCLEO-F401RE.I have successfully imported the exampl...
I'm using a ST25R3911B-DISCO for a project and I need to use the UART interface, instead of the USB one and the software provided by ST, to send commands (like INVENTORY, READ BLOCK, WRITE BLOCK) and receive the corresponding information.Is it possib...