Lt spice model for SMA6T28CAY
Hi everyone,I am searching for LT spice model of SMA6T28CAY diode. can someone please help me to find this and integrate in LTspice application. Best Regards Vedanth.
Power management
Discuss power management solutions. Ask questions and find answers on voltage configurations, short circuit protection, and programming.
Forum Posts
STPS5H100AF operating temperature?
Regarding the STPS5H100AF, the datasheet states that the storage temperature is -65 to 175°C, but there is no mention of the operating temperature.What is the operating temperature?
Resolved! Misleading statement about TS function of BQ25120A
Hi,Our development board uses BQ25120A for battery management.In the datasheet section 10.2.2.1 Default Settings, there is a statement:• If the function is not needed, connect TS to the center tab of the resistor divider between VIN and the ground.(p...
STPM801 with a I2t characteristic
In our application we use the STPM801 as a switch and fuse. The fuse characteristic is, by default, very linear (except some filter/blanking times). Is it possible to give the fuse a I2t characteristic like old fashioned fuses/thermal fuses?I did exp...
Resolved! DIODE IDENTIFICATION
Hi,I can't find any information about this diode. What is the actual name of this diode on ST?DEGP025
EVAL BOARD L9301 SPI COMMUNICATION
How to drive HSD and LSD pin using SPI command in EVAL BOARD L9301 and we need technical details what frame we have to send form our ECU to actuate the LSD and HSD drive and even more technical details related to this we are waiting for your immediat...
Resolved! identify this smd component
hi everyone, can anyone steer me to a Datasheet for this, or an identification please? thanks, elts
Resolved! Qi2.2 25W receiver
Hello,We see that there are Qi2.2 25W transmitters that have been certified. Is there any roadmap for Qi2.2 25W receivers?Thanks
Spice Model of VIPERGAN65D
Hi, Does Spice Model of VIPERGAN65D available? If so from where can I download it?
Problem with in rush current to the DC Link Capacitor
In the DC Link Capacitor i am facing a problem like i am getting 260Arms as the inrush current for my motor controller. Although my overall operating current is 160Arms maximum. Suggest me some methods to reduce this consition.
