Discuss power management solutions. Ask questions and find answers on voltage configurations, short circuit protection, and programming.
Hi,I am looking to use the STM6710DWB6F as a quad-channel voltage supervisor, specifically for 3.3V, 5V, 6V and 12V rails. The datasheet specifies V1IN = 5V, V2IN = 3.3V, V3IN = 1.8V, and V4IN = adjustable. It seems obvious use V1IN and V2IN direct...
From what I can read on this diode it is from ST for sure, and it says G beside the logo, the next line is BEX, and the last line is GP048. Any help would be appreciated
Hi ST teams,I am currently planning to develop a project using the STWBC2 series. However, I have found that the technical resources available on the official website are very limited. Could you please provide or recommend a more comprehensive set of...
Dear Forum members. Could you please help me with a .PDF version of the suggested PCB footprint for the LDLL16EN (QFN32L 5x5 mm package) not the Ultra librarian or Samac Sys options. The plane original pdf version. Thank you
Dear Forum members. Could you please help me with a .PDF version of the suggested PCB footprint for the L99LDLH32TR (QFN48L 7x7 package) not the Ultra librarian or Samac Sys options. The plane original pdf version. Thank you
Hi everybodyI need some help to identify this ST micro diode , can anybody point me in the right direction please?I have tried searching for the numbers on the diode with no luck.regardswasim
Hi, I am trying to configure the L9026 through SPI communication, but I am confused about configuring the CFG_1 and CFG_2 registers. In section 7.4.1 (PWM Generator), it is mentioned as CFG_1.PWM_DIV_GEN, but in the CFG_1 register there is no fie...
HI Sir, "Could you please check the following switching frequency waveform images? The setup is: 24V input, 12V output (max load ~1.8A), R-FSW = 68kΩ, inductor = 15μH, and COMP configured as 680Ω + 33nF (parallel with 1nF) — see the images below. Thi...
Hello - I'm looking for a footprint or land pattern to use for designing a PCB around the VNH9030AQ. I'm sorry if I've overlooked it somewhere--can anyone point me in the right direction? Thank you for your time!
Now that STBC15 is marked as NRND, is there any direct or close substitute that is planned?
