I am writing the c# application using Feig "FEDM for NET" library to communicate with ST25DV02K-W1/W2. I want to use PresentPassword and WritePassword command. ST25DV02K-W1/W2 is recognized by the library as 'TH_ISO15693_STM' tag. The 'TH_ISO15693_ST...
Tag EPC, User memory Write using STUHFL library. Would like to know the procedure to do the Tag write using ST25RU3993-HPEV. If someone can refer any example project using STUHFL code wrapper of C#, it'll be helpful.
Hi,I am using ST25RU3993-EVAL board to measure temperature from an RFID tag RFM3200-AFR. Before reading the data from the memory bank, It is mentioned that, we need to send a select command to activate the temperature sensor. Right now I am using the...
We are working on RFID products, I can only find the installer about TSW-ST25RU001 from the website, can you provide me with a source code of STSW-ST25RU001 for reference? Thank you so much!
Is there any limitation for tag write password length? Because in C demo, its limited the length of password as 4. But our tag is protected with 8 digit password. Would like to know how to handle the 8 digit password?is it only the modification of 'S...
Hello,I'm facing problems while setting up the GPO interrupts from the evaluation board.My application is to write some data using I2C to the tag, and then read it from a reader. TO avoid collisions (writing to EEPROM with I2C when there is NO RF ope...
Hello,I'm facing several problems in trying to correctly configure the GPO register and read the GPO pin. My application is to write I2C data to the tag and, to avoid collisions with the reader, use the GPO pin to avoid I2C writes when an RF reading ...
(EDIT: Already responded on X-CUBE-NFC6 not a valid X-CUBE-Expansion and missing files from wmmcmj by Markus GIRDLAND (ST Employee))I have been unable to install X-CUBE-NFC6 software expansion package for STM32Cube. I have two installations of STM32C...
Hi everyone,I'm new to this forum. I'm facing a problem: I'm using the X-NUCLEO-NFC03A1 evaluation board mounted on a NUCLEO-F401RE. I'm also using, with an Arduino UNO, the X-NUCLEO-NFC04A1 tag evaluation board. I'm using the Arduino IDE for now, bu...
Hi,I use a ST25DV04K with STM32CubeExpansion_NFC4_V2.0.2. is it possible to set a RF password with an I2C function ?if yes, Could you give me some examples ?Best regardsMickaël