Following this:https://wiki.st.com/stm32mpu/wiki/How_to_configure_U-Boot_for_your_board As the default config used stm32_defconfig.At the step make menuconfig disabled PMIC in device driver -> power and enabled regulator power .Though, this causes...
Hello We are using timer peripheral in STM32MP157 Cortex -A7 core 0 processor. In this, we enabled TIM2, TIM3, TIM4 in RCC APB1 peripheral enable for MPU set register, now we unable to use these timers (not getting interrupts) in Cortex -A7 core...
Same or related postshttps://community.st.com/t5/stm32-mpus-products/op-tee-error-on-new-v5-0-0-sdk/td-p/578239/page/2https://community.st.com/t5/stm32-mpus-products/op-tee-error-tzc-permission-failure-on-new-v5-0-0-sdk/m-p/584339Custom STM32MP157AAA...
Hello everyone,I am trying to apply the hello world example from stm32MP1 workshop. everything works fine for me. However, when I try to run the application inside stm32mp1 it shows me this message. version `GLIBC_2.34' not found.I tried to install n...
Our board is using STM32MP15 and doesn't use PMIC, when we try poweroff command, it seems to work but after around 30 seconds, the board reset automatically.During this time, I see power consumption just goes down a little bit.Does anyone have same i...
Hello,I was wondering how hard is to convert the simple OpenAMP_TTY_echo (I have it installing the STM32Cube_FW_MP1_V1.6.0 package from STMicroelectronics' web site) to a Makefile driven project.I need it so, because the firmware auto building of my ...
Hi, I was following the STM32MP157F-DK2 tutorial for developing on ARM Cortex A7. I have two problems:1) Starter package - i have using STM32CubeProgrammer to download the image to a new SD Card, but the board failed to load Linux2) i have tried the ...
STM32MP135 is connect on i2c bus to 3 devices:LM75PCF8563INA233I am using linux kernel 5.15.24 synched with your github repo. LM75 and PCF8563 are working fine. INA233 has problems to manage the PEC (Packet Error Correction)I am seeing lot of this er...
Hi,Appreciate any help on how to enable u-boot splash screen during boot. I am using STM32MP157F-DK2.Thank you.
Objective: I want to debug using STM32MP157F-DK2 Cortex M4 + STLink + VSCode + GDB.I am planning to perform the following stepsstep1. Enable building the elf file from VSCode.step2. Connect VSCode and GDB.Questions:1. I want to create a Makefile for ...
