Hi, I have a STM32MP157F-DK2 with a firmware running with remoteproc and using remoteproc and rpmsg drivers to communicate with userspace through ttyRPMSG0, created at firmware init with libmetal and openAMP libraries. After multiple days of research...
We have set SDMMC1 pin muxing like below. How can we boot from emmc on SDMMC1 interface??? Where should I do partitioning for emmc??Kindly give solution- D14 PC8 SDMMC1_D0A16PC9 SDMMC1_D1B14PC10 SDMMC1_D2C14PC11 SDMMC1_D3A13PB14 SDMMC1_D4D9PB12 SDMM...
Hi All, I am working on board bring-up of custom board based on STM32MP157f-DK2. I am using the Starter Package provided by ST. I am able to flash SD card and boot the DK board, via USB interface, but I am facing some issue when I flash via UART inte...
Hi,I like to use spidev_test tool:https://wiki.st.com/stm32mpu/wiki/How_to_use_SPI_from_Linux_userland_with_spidev#Installation_on_your_targetI am following this guide for compiling the tool by developer package:https://wiki.st.com/stm32mpu/wiki/How_...