Hello,How do I use the S25R95 on an IRQ/Callback basis?What I have found so far is that there are three callbacks (UpperLayer, PreTxRx, PostTxRx) you can use for the ST25R95, but these are only available during the regular polling/running process.I a...
I'm experimenting with the St25ru3993 eval board on raspberry pi 3 b +. Initially, I downloaded your program called Reader Suite to get the correct parameters. There I entered the parameters to read the tags correctly. Then I imported them into sourc...
Hello,I downloaded from your site the CR95HF EMI filter calculation tool. But the xlk (Excel backup) is linked, not the xls. Could you provide a link to the xls file?Best regardsRadek Kreczewski
Hi,I'm working with M24LR Discovery and I would like to Flash demonstration firmware of RF transceiver after erasing flash using STLINK/V2 utility. I am able to erase the Flash but while I'm trying to Flash the .hex or Binary file, following error me...
Posted on November 14, 2016 at 12:42Hi, I'm working with M24LR Discovery set and I would like to get back to default settings and firmware of transceiver demonstration board. I've downloaded sources from ST website, but my environment has got a prob...
Hi all,how can i send in card emulation mode extended apdu? it's possible?
Hello!I have been working with the NFC05A1 NFC Reader in combination with a G070RB, but am momentarily stuck on how to use it in my own program.I have followed all the steps given in an other post with a person having close to the same issue: https:/...
I'm looking for a simple, low cost tag (passive ~1-2 cm square nominally transmitting a unique ID one-way) & reader (antenna & analog front-end) solution. Although read range data is ferociously difficult to find, it must be readable at a distance >=...
The st25r3916.pdf data sheet includes Table 23 which lists the Initiator operation modes. This list includes ISO14443A/B but excludes ISO15693.