Forum Posts
Resolved! Need help identifying part
There are one of these for every relay on board. Thanks for the help.
Resolved! SD Card Alternatives
I'm trying to find an embedded solution to replace an SD Card.Basic non-volatile memory, I2C or SPI read/writes.I spotted ST NVRAM, but can't seem to find much about it - is this a new or discontinued product?Are there any other options that I should...
Resolved! Hi, I have a board with IC 1821-5613 REV1.4(H99TU0406) manufactered by STM and cannot find datasheet for it internet.
Usually the ST has a lot of documentation of their products. I also found few people also write in Internet that it is impossible to find any information about this ST productIf somebody can share more information about this IC
Resolved! May I exchange the in/out of EMIF03-SIM02M8?
Hi,May I exchange the in/exit of the EMIF03? As the pin name indicate there are in pins and exit pins. But from the internal diagram, the ins and outs are exchangeable.Thanks.
Resolved! What is the body marking of M24C32-RMN6TP
Please help to provide the body marking surface of this material. There is no description in the spec, so it is impossible to confirm whether the material used is correct. Thank you! MANUFACTURER: ST MANUFACTURER PN: M24C32-RMN6TP
Resolved! I would like to kwow if my SM6T18A/CA on the input connector of my product is compliant with the no destruction of my electronic which is located just after when fast Transient 61000-4-4 is applied.
Hi Sir,I currently use a SM6T18A/CA on the 12V+/- 5% power supply input of my product.After this protection are located many electronic components with absolute maximum rating voltage levels (continuous) given from 13,2V to 18V. After applying the tr...
How do I replace the memory that came with the EVAL-SC003V1 with the STM32CubeProgrammer? It firstly erased the memory on the EVAL-SC003V1 because the default is to not skip flash erase before programming.
I'm not certain that the default memory file for the EVAL-SC003V1 was provided in any of the zip files I downloaded. Is replacing the memory sectors between the STUSB005 GUI the correct way to program the EVAL-SC003V1 board? The sectors from the GUI ...
Resolved! What does the -E suffix stand for? In ST1284-01A8RL-E
Hello all can you please help me find out for what the -E suffix stands for. There is no reference in the datasheet(s) i've stumbled upon.Many thanks in advance
