I've been seeing some unexpected failure modes while reading T2Ts with an ST25R3916. Every ~300ms, the device sends a wake request, and if a tag is detected, goes ahead with the reading process. If a tag is detected and an error occurs anywhere in th...
Hello, I am trying to get the ST25PC app to connect to a FEIG-CPR30-LCN9620 which I believe should be supported; however I not able to get the correct drivers to do so(Which I believe is the problem); I downloaded the most recent drivers from Feig we...
Hello, I am trying to enable the Mailbox functionality on ST25DV64KC-DISCO board. I am using the NFCTap project,And inside it added my own storyboard and a View controller.This view controller first detects a tag at launch in view didload,then it fet...
Hello,I have a question need your help!About :MCU L431(80MHz),SPI 5M,IC ST25R3916. NFC06A1I use "rfalNfcvPollerReadMultipleBlocks()" read two blocks at a time,but I found that it takes 9 ms to read successfully. How can I shorten this time?
Hi I'm looking for a product able to perform ISO 14443 B emulation and maybe emulate a simple tag like SRI4K, do you have anything like that?#nfcThanks
Hi everyone,I have difficulty understanding in which part of the code to intervene to modify the RFAL example code in card emulation to adapt it to my hardware.The example works perfectly on the NUCLEO-F401RE with X-NUCLEO-NFC08A1. Now that I have bu...
Hi,I'm currently using a ST25R3911B-DISCO board at work.Yesterday my laptop was running Windows 10 Enterprise (don't know the exact build version) and everything was ok. The board was being discovered by ST25PC-NFC and I was able to use it with our c...
We've slightly modified your app ST25NFC to query our ST25DV device. It sends some measured values via NFC using MailBox (FTM). From the app, we send the same query repeatedly (cca 2 sec), and the device's response varies slightly (the value, not the...
Hello together,I'm writing code that is supposed to write a message to the ftm mailbox. For the setup I authorize FTM in MB_MODE. Also I enable FTM via MB_EN. After that I'm writing to the mailbox. On my oscilloscope I can see that the device sends t...
Hello everyone!I'm working with the NFC08A1 board (ST25R3916) and trying to use it in NFC Reader mode. At the moment, I’m focused on writing and reading the chip’s registers via the SPI protocol.I've conducted several tests on the firmware side, but ...