Hey,I have a custom made board/device which is using 4x VL53L4CD Tof Sensors to measure the distance. I have trouble to calibrate the sensors correctly or get correct values from them from time to time. Sometimes it works well - sometimes it does not...
I'm using the example project provided for the VL53L5CX and it works fine with the default 4x4. The `vl53l5cx_init` method within the vl53l5cx_api.c is where I believed it should be configured in this section where I passed in VL53L5CX_RESOLUTION_8X8...
Hi everyone,I'm developing a tamper detection circuit for a meter enclosure. I'm considering the STHS34PF80 infrared proximity sensor, but I'm struggling to find reference materials or application notes specifically related to tamper detection using ...
I need to measure a distance within a 1 degree field of view (FOV) in front of the sensor at a distance well within the range of the sensor. I know I can't use focusing optics on the emitter side without changing the laser class - so I won't. Using a...
Hi，I have two questions to ask.1、How do I adjust "VL53LX_MAX_RANGE_RESULTS"and "VL53LX_MAX_USER_ZONES" if I want to get a best single target of data?Would it be better to change them all to 1? It's not in the manual.2、VL53L1CB has a single-target get...
Hi,i saw that the VL6180X is set to NRND.I need the functions of gesture detection and ambiation light measurement.I want to use it in a new product which should be produced more than 10 years but in this case i dont think that this is the right one....
Hi,I would like to ask about the difference between the two modes of offset (PerformOffsetSimpleCalibration and PerformOffsetPerVCSELCalibration).Because when the crosstalk calibration value is high(calibrationData.customer.algo_crosstalk_compensatio...
(A translator was used for this inquiry.)Hi,I am using the vl53l0x sensor.I would like to inquire about the detection range of the sensor.What value do you get when the wall you want to measure the distance against is tilted? (Refer to image1)What po...
I want a code to reset the sensor, and put it before all my routines so I can get the MCU and the sensor to re-synchronize.That are the steps of the technique to reset 1.to find gpio pin has the ability to lift and low And Connect that pin to the Xsh...
Any way how can I get in touch with ST on availability on this product? We would like to implement this into our devices, a devkit or hardware preview would help, we had previously integrated with the VL53L8 and VL53L5 which the result are good, and ...