Hi,Actually , I need to measure different Load appliances which is connected to STPM32. May i know the connection for switching STPM32 IC. How to connect multiples load which using this IC. Requirement: Measure the Load Appliances with Energy Meter I...
The older SPWF01 is still active, I don't understand why SPWF04SC is NRND?Has ST plans to replace the SPWF04SC for a newer wi-fi module?Ari.
We are looking for part M68AF127BM70B6 but what we receive is M68AF127BM70B6U.Already tried to check datasheets to know what does suffix U means.There is no information can be found for this particular suffix.Kindly please share what is the suffix U ...
I am trying to use the L7980A as a current driver for a laser diode. The laser operates with 1.65A at 8.7v. I am aware that the laser needs to carefully controlled, to avoid over-voltage killing the diode. I'm using eDesignSuite, but the design gives...
I have an LM235 temperature sensor separated from the measuring device 5 meters.When an RF is induced to the LM235, it measures wrong temperatures. I have tried to minimize the problem by putting capacitors on the sensor pins but I have not obtained ...
I need to reball a FLI32626H that is clearly presenting soldering issues. One can see the chip is tilted with the naked eye. It has been reflowed twice to no avail.According to ST support, this is a legacy product, and ST no longer has technical reso...
I'm using STM32L4A6VGx , MT25QL256 NOR Flash connected with SPI. I'm trying to read the ID but didn't get any response except 0. Here is the code I wrote: // Select Pin HAL_GPIO_WritePin(Select_GPIO_Port, Select_Pin, GPIO_PIN_SET); HAL_Delay(10); HAL...
I have designed an isolated AC-DC converter, 300 to 590V AC input (400V AC nom) to 24V, 4A output using the L6566-BH Controller in eDesignSuite. Attaching the details herewith.Any further guidance regarding the Design implementation in actual Hardwar...
We are planning to use the SCLT3-8BQ7, but do not want to connect any LEDs to LDi outputs of the chip. The datasheet does not mention how to connect these pins in this case.Can you please tell us if we should leave these pins floating?NOTE: This ques...