Others: hardware and software

M95M02-DWMN3TP/K EEPROM Identification Page (RDID) Reading Issue

Hello,I have M95M02-DWMN3TP/K part number EEPROM and have a issue that I cannot read Identification Page (RDID) using VHDL test bench. Write Protection and Hold are driven high. Despite sending x"83" + x"00" + x"00", there are no return values. Statu...

VNI8200XP - SPI command activates valves only for <500ms.

+24V Supply, 16-bit SPI, I send the proper bytes to activate valve 1-8, the proper LED(s) is activated as expected, but only for a short period, then it turns off. The driver responds with the correct byte, no errors, parity check is clean. WD_EN is ...

Part#: M27C64A-15F1; Does anyone know what the "N" stands for in the die marking? Is this device a "NMOS" and not "CMOS" ?

Urgent Request!

Hi Where can the upper computer software (SPC5 Loader) be downloaded? Regards

Device: STV5730A. I'm looking for inventory on the STV5730A. I'm finding inventory on the STV5730A1 or STV5730A-1. The data sheet does not mention an A1 or A-1 version.

Does anyone know the difference between the standard STV5730A, and the STV5730A1 or STV5730A-1 that I'm finding on the open market? The suppliers confirm that they are ST product. I can find the Data Sheet for the STV5730A, but no reference to an A...

I think there is a bug in the STM32CubeIDE Version: 1.4.0 Build: 7511_20200720_0928 (UTC), section “device configuration tool�?, section STMicroelectronics.X-CUBE-TOUCHGFX.4.15.0 Mode and configuration.

When Graphics Application is checked, a folders tree starting from TouchGFX, with files like GFX2.touchgfx, etc, is generated. It’s OK.When the .ioc file becomes complicated (as the example I attach), it seems that TouchGFX is replaced by Src and all...

Is it possible to damage a STBP120 device by attached a low impedance voltage source set to 26V instantly to the input pin?

I have found when tapping a powered bench DC supply at 26V to the input pin of this OVP protection device, I seem to have destroyed the device. I measure 2.5 ohms from the input pin to ground and I measure 140 ohms between the input and output pins.

Hi, I would like to use STEVAL-STWINKT1 as HID (mouse emulator). Is that possible? If yes, is there an examlple project? Thanks.

Can you help me to identify this part? GF499? No reference in the database

I was looking at the database and I did not find this component. I would like to ask help to identify it because I believe that is a discontinued product and may be I am not looking in the right database. Can you help me? I attached the image: