Other: hardware

STB6100 Tuner cause an arbitration lost in the I2C interface. See additional details.

Hi,We have the STB6100 Tuner in our products, many of them are in the field.Lately we have been working on a bug in which the STB6100 cause an arbitration lost in the I2C interface.It seems that writing some specific values to the registers cause thi...

Impact of Synchronisation jump width setting in CAN network

My CAN Network is working with 500kbps, One if the ECU had SJW(Synchronisation Jump Width) setting as 2 TQ(Time Quanta) whereas other ECU’s in Network had SJW setting as 3TQ. Will such CAN network work ? What is impact on ECU having SJW setting as 2T...

about ecopack2

Hi,Does EcoPack2 comply with RoHS2 (2011/65 / EU) compliant?

The QR code on the back of SPBTLE-1S shows LOT CODE. Do you know how to scan it? thank you very much!

i try to interface i2c with cypress 423054

i am able to read the default data on address 0x50, but i am not able to write on same address

i am using m24m01 eeprom i am able to read deafult values on address 0x50 i am not able to write on same

about part KF60BDT- 1) is there a PCN for the EOL of this part ? 2) is there FFF recommended replacement for this part ? 3) if not FFF - is there a substitute part / series ?

STUSB4500 Behavior Issues

I've set up two different STUSB4500 ICs, my first board, when plugged in will fluctuate its output (measured from the output of the MOSFET) from 0 to 5V every few seconds or so. EDIT: I went probing on this first board and found the 100K resistor was...