Ask questions and find answers on STM32 microprocessors, including hardware, power, DRAM, flashing, interfacing, device tree, and peripherals.
On DK2, ADC is used to measure the voltage on cc lines, how to skipcan u give me the yocto steps to follow on commenting the following line in uBoot Device Tree:do u have to create a new layer or can we edit the patch file in the uboot device tree a...
"is there possibility we can auto mount a usb when connected to usb host and how to build the udev-extraconf package for my stm32mp157f-dk2" how to build this please give the steps to build for my stm32mp157f-dk2 as i want my pendrive to mount aut...
Can I use MMAction2 with TSN or SlowFast behavior recognition models and deploy them to the STM32MP257? Does the STM32MP257 support 3D CONV operators?
Hello.We are developing a device with the STM32MP257 and we will not have a USB Type-C connector in our design. We plan to use the USB3DR as a USB2.0 device with a USB 2.0 connector to USB boot (USB boot for flashing). Does the STM32MP2 embedded boot...
I have had difficulties programming the STM32MP257 via stm32cubeide. I followed the first few steps to flash an OS image onto the board using the section populate and boot the image, from the STM website. When trying to flash IOC generated code via s...
Dear All,I'm having problem to get DFU over USB running on custom board.In general device can boot from SD card and with no SD card it can be detected via uart4 by STM programmer, so it enters DFU as far as I can tell.USB DP/DM is connected to DP2 (b...
Hello,I am testing a custom board based on STM32MP257FAK3 with two DDR4 MT40A1G16RC-062E_B devices, for a total of 4 GB (32-bit width).I have correctly set up the main configuration files to work with the PMIC and UART. I also exported the PCB layou...
Hi, I tried exporting the IBIS model from ST website. On importing model to SI tool I can see that there is no model assigned to DSI lines. It is showing NC. Can you share the IBIS model with MIPI drivers in it. or share some IBIS model which I can u...
Hello, I am working with the STM32MP135F-DK development board and trying to interface the onboard GC2145 camera with the STMIPID02 MIPI-to-parallel bridge. The goal is to convert the camera's MIPI output to parallel data, which is then received by th...
Hello I am planning to use STM32mp257Fak3 with DDR3L (16bit and 32 bit saperately),can you suggest some DDR part no and it's sonnection.
