Hi,I am only a bit familiar with embedded linux. I will develop a demo project with STM32MP157C-DK2 with C language:on M4 side, a sensor(BME280) and a vantilator (5v) are connected. Sensor is to read periodically and three numerical values( temp, hum...
stm32-ipcc 4x001000.mailbox: Try increasing MBOX_QUEUE_LEN remoteproc remoteproc0: stm32_rproc_kick: failed [vql, err: -105) Hey all,I'm working with the OpenSTLinux EGLIFS QT image, and having issues running the OpenAMP TTY Echo program.When I ...
sed: can't read /home/letter/new-development/build-openstlinuxweston-stm32mp1/tmp-glibc/work/x86_64-linux/ncurses-native/6.1+20180630-r0/sysroot-destdir/home/letter/new-development/build-openstlinuxweston-stm32mp1/tmp-glibc/work/x86_64-linux/ncurses-...
Hello, I trying to make the example in: https://wiki.st.com/stm32mpu/wiki/Getting_started/STM32MP1_boards/STM32MP157C-DK2/Develop_on_Arm%C2%AE_Cortex%C2%AE-M4/Modify,_rebuild_and_reload_a_firmwarebut after SSH password window (here i put root in pass...
Hi, I used the below link for building OpenSTLinux Distribution.https://wiki.st.com/stm32mpu/wiki/STM32MP1_Distribution_Package As mentioned in the step 7 "Flashing the built image", there should be a /deploy/image folder for images. But i didn't fin...
I would like to understand what the Eclipse IDE is doing to start the debugger, so that I can move away from using it. I much prefer CMake and other tools. I'd be grateful for any assistance. The wiki section for this is TBD.I'm not too familiar with...
Hi,As i was testing the limit of how many virtual uarts i can create, i found that the limit is actually 4:Using debug tracing i can see that the channels get created inside the code (here i am creating 5 virtual uart) but only 4 ttyRPMSG are created...
Good evening,since NAND flash can be addressed pagewise only (I guess STM32 flash is NAND) and I am able to write for e.g. a single byte to the page, will the whole page gets erased during every write operation? My presumption is that the page gets b...