Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Hi, I am trying to use STUSB4500QTR in a new board. In my design, the STUSB4500QTR is supplied from a USB-C power adaptor. The application intended for use of 20V supply. When connecting the adapter to USB-C port for first time, there is 20V on outpu...
Hello, I am looking for the IBIS model of EEPROM (M95020-WDW6TP) for the SI analysis. Do you have it available?Please let me know.
Hi Team,i am using STEVAL-MKBOXPRO and want to modify STSW-MKBOX-BLEDK BLE_SensorDemo code to increase the RF output power to its maximum 8dBm.I found that this can be done modifying the file Users > sensor.c file in STSW-MKBOX-BLEDK\Projects\BLE_Exa...
I want to connect a Q7 board to a tablet via USB. The Q7 board is a power source (provider) and a USB device (UFP). What USB PD V3.0 solution is available? Something like STUSB4700 with PD 3.0 and not only for Power-Adapters would be great.
Dear Ms/Mrs/Ms Hello, this is Aaron who in charge of APG in WT Korea.I would like to receive CMRT, EMRT new(latest) version. CMRT : ver. 6.4(Revision April 26, 2024), please refer to the attachmentEMRT : ver. 1.3 If you have any questions or concerns...
I am really confused about driving mosfet. read many documents regarding this. some documents says gate current may be 2.5A, some says it may be 50mA.what is the actual formula to calculate gate current?I am using IRF510 (H bridge conf.) at 24V, 700 ...
Hello,I am working with STEVAL-SPIN3202 to develop motor control solution. I am using the Motor Control Workbench 6.2.1. I could generate the project using the workbench, however when i Connect the evaluation board, window with FAIL.txt opens which r...
Hi,cleaning out my drawers and found some 8-pin IC’s wirh the marking: ST CHN NESSSN K7U826 Does someone know what these do and have a data sheet?Thanks,Bas
We would like to inquire if there is a solenoid valve drive solution that can meet the following requirements:PWM frequency 0-5000Hz, current 0-3A , can superimpose dither signal 100-1000Hz, 0-600mA, dither waveform: sine wave and triangle wave
Hello! Hope your team is well and everything is fine!I'm currently using two stpm34 chips on a custom board connected in cascade to perform voltage and current measurements.Right now I'm performing measurements at a specific time through a timer inte...