Posted on April 09, 2018 at 14:17We are using the M25P16 memory and we get one memory that we can't do a bulk erase.On this one, we only do this action in the following steps:- Complete erase with the bulk erase command and polling for the end- prog...
Posted on February 09, 2018 at 21:06Board boot okWiFi connect Pc or Tablat ok (192.168.0.2)ping 192.168.0.1 okhttps://community.st.com/external-link.jspa?url=http%3A%2F%2F192.168.0.1%2Fcommand.shtml load okclick to button (Send the command) G-conde ...
Posted on June 06, 2018 at 07:37I want to know about the parts in the attached photo.I want to get a datasheet for the parts shown in the picture, and I want to know if I can replace it with a company other than ST. Where should I search for this pr...
Posted on December 22, 2016 at 19:47I have bought item for UPSD3354DV40U6 from open market. but, the surface was blacktopped it. Is that possible to do blacktopped on the surface at factory side?
Posted on June 06, 2018 at 08:07I want to get a datasheet for the parts shown in the picture,and I want to know if I can replace it with a company other than ST.Where should I search for this product?#please-let-me-know-what-this-is.
Posted on June 01, 2018 at 10:16Recently we got some samples of STVVGLNAT. Parts label show surface marking ''STVVGLNAT L4AA'' but parts surface show ''L4AA'' only. We cannot find the detailed information about the marking from datasheet. We hesitat...
Posted on May 31, 2018 at 22:32Dear Sir or Madam,I am trying to use the timer TS556 in monostable operation with 3.3V power supply. I implemented the application schematics of figure 4 (page 13) of the TS556 Application information (DocID4078 Rev 3)...
Posted on May 31, 2018 at 11:07Hello everyone ,My task is to store key securely using TPM 2.0.can we interface ST33TPHF20SPI with 16 bit controller?plese give me steps to perfom storing key in Tpm 2.0 based chip ST33TPHF20SPI using 16 bit controlle...
Posted on May 30, 2018 at 13:35I have seen, that all wifi-modules are not recommended for new design. Are you planning to publish a new one? If so, will it has the same dimensions and a similar pinning?#spwf01sa #wifi #spwf04sc #spwf04sa #spwf01sc
Posted on May 22, 2018 at 10:16This is regarding the STEVAL-IME011V2 evaluation board based on the STHV748S 4-channel 5-level high voltage pulser. Can I please know if I can connect my own transducer to the high voltage output SMB connector, without...