Microcontrollers

Resolved! I have SPC560P and Eval 9907-H but have got some problems. 1. I tried to install MCTK library in SPC5Studio even with newer files but still got problems please see file Problem_MCTK_library. 2. I can not make USB driver to work with Motion Control.

Resolved! I'am wondring if there is any application note or document about CAN bootloader for SPC584B? this bootloader does it support UDS protocole? What is the tools used to validate CAN bootloader on this product?

I'am working on automotive project that the client need a validation plan for automotive device using SPC584B MCUI have did a search on st.com site to find somthing about CAN/UDS bootloader but i did'nt find the appropriate document for my need.any s...

Resolved! I'am wondring if there is any application note or document about CAN bootloader for SPC584B? this bootloader does it support UDS protocole? What is the tools used to validate CAN bootloader on this product?

I'am working on automotive project that the client need a validation plan for automotive device using SPC584B MCUI have did a search on st.com site to find somthing about CAN/UDS bootloader but i did'nt find the appropriate document for my need.any s...

Resolved! How read the EMIOS counters?

I need to read the EMIOS 0 channel 5 counter.How can I solve it?

Resolved! there is some problem in SPI config based on SPC58NN

hello guys, I want to config SPI to communicate with TJA1145 .the 4 pins are shown in the picture. but I test the signal by OScilloscope and I found nothing in the four pin which means no meaningful signal. for example the CS pin is always high and n...

Resolved! Which paths should I include to correctly compile the "SPC58ECxx_RLA Network Ping Test Application for Discovery" example

I have the following configuration, but although I include the ones that I consider correct, I still get many errorsThe errors are supposed to be related to the tcp-ip component, but I already included it and I don't understand what is wrong, maybe I...

Resolved! I configured 86 slot one cycle , but configurable message buffer number of the first message buffer segment and second buffer segment are total 32 . So do i read/write all slots in cycle despite message buffer number is 32?

I am currently developing a Flexray driver. I cant understand a few point. This message buffer configurable like that : "configure each message buffer by setting the configuration values in the Section 21.5.2.65: Message Buffer Configuration, Contro...

Resolved! Do I need to complete the components on the SPC58EC-DISP development board?

In the schematic of the ethernet configuration it is indicated that 3 components are not assembled: R28, R33 and R120. My question is, should I solder them for it to work?

Resolved! Any story about SPC56ECxx and MPC5646C? they seem to be the same

when i searched datasheet about MPC5646, i found a datasheet of SPC56ECxx, this two mcu have same hardware pin, could they be used as substitution of each other?

Resolved! i need SPC582Bxx_MCAL40_100 for EB tresos