I get the following error message when trying to use pinctrl with a regular GPIO....[ 4.580426] stm32mp157-pinctrl soc:pinctrl@50002000: pin PA13 already requested by gpioleds; cannot claim for GPIOA:13[ 4.590464] stm32mp157-pinctrl soc:pinctrl@50002...
I am trying to operate two devices using QuadSPI in the STM32MP131 bare-metal environment. Currently, an external Flash is being used in QuadSPI Bank1 in dual mode, and I am attempting to use another external device in Bank2 in quad mode.The issue I ...
tl,dr: No boot log or root term via ST-LINK connector on STM32MP157F-EV1. Haven't tried UART 4 yet.This is related to:https://community.st.com/t5/stm32-mpus-products/i-get-output-via-uart4-but-not-via-st-link-and-i-cannot-input/m-p/135067 Reference: ...
Hello,I am using the STM32MP257x-EV1 board with version 2022.10 of u-boot-stm32mp (with patch 0001-v2022.10-stm32mp25-beta.patch from commit dc5d7824 made on April 12, 2024).When compiling u-boot + stm32mp257f-ev1.dts, only the eth2 interface is func...
I'm still trying to get a fully error free bootup on the stm32mp151 based board. I'm using ST git's for the bootstages and kernel/rootfs are build using the ST yocto layers.But because i'm unsure which are actually errors and which are just warnings ...
We have a custom board based on STM32MP157C-DK2. U_boot shows a splash image(logo). Then U-boot starts the kernel from a fip image. I the same fip image there is a ramfs partition in cpio.gz format which is used as rootfs by the kernel. When kernel s...
Hello,i'm currently trying to boot a custom board which has the bare minimum of STPMIC1, SDRAM and USB closely resembling the STM32MP15-DISCO evaluation board except on power delivery (VBUS from USB-C is switched via STUSB4500 but _not_ connected to ...
Hello everyone,I have a custom board based on STM32MP157A (rev. Z) and I am trying to boot from emmc; I am able to boot sucessfully from SD card; I flashed the same image to the emmc with the ST MX Cube Programmer and, if get into u-boot from SD card...
Hi, i get this error when uboot starts on custom MP153D board: E/TC:0 tzc_it_handler:79 TZC permission failureE/TC:0 dump_fail_filter:420 Permission violation on filter 0E/TC:0 dump_fail_filter:425 Violation @0xdff09000, non-secure privileged write, ...
Our board is similar to STM32MP157C-DK2 Disco board - All the Developer packages have been installed, When the power supply is given, all the test point voltages are in desired level. But the MPU not even clearing FSBL and exit with ERROR: DDR addr b...