Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Split from: https://community.st.com/t5/stm32-mcus-boards-and-hardware/how-to-program-multiple-stm32-mcus-over-swd-or-otherwise-using/m-p/161620 I am also trying the same thing with a bluepill and blackpill however I am unable to program it that way....
Hello,I'm facing an issue while trying to program my WeAct STM32F411CEU6 board using a genuine ST-Link/V2 programmer via SWD interface. The ST-Link firmware version is V2J38S7 and the target voltage is detected as 3.14V.However, every time I attempt ...
Hello TeamI am writing that I want to use TSC1801 bi-directional current-sense amplifier in my current project. I want to validate it through simulation in LTSpice, so, please provide a LTSpice compatible TSC1801 LTSpice model. This would be helpful ...
Hello everyone, Who so ever is seeing the post please help me out I was trying to upload code into STM32 blackpill (STM32F401CCU6) using USB cable and STMCubeIDE and STMCubeProgrammer but I think my STM board had got locked in the DFU state and eve...
Hi,Pretty new to STM32 but reasonably comfortable with ESP32, Pico and 40 years of C++. So old enough to expect it to be me.Cannot get blink to work with blue pill 32k using cube ide on ubuntu 23.04 with while (1) { /* USER CODE END WHILE *...
Hi, I bought a module of STM32F103C8T6 with a 0.96" LCD. I managed to find the LCD library in Keil MDK. However, I am checking of anyone has successfully ported to STM32cubeIDE?Thanks.
I am using a Bluepill Board but it is not functioning as expectedHow do I verify if the chips on my Bluepill Board are genuine or a fake knock off?
Hey there I'm new to develop STM32 software ,my setup is 2 dev kits with bluepill cards ADC sensors buttons etc (they ll use same code and comunicate each other ), I have doubt on Uart COM, because I see a problem on PA2_EX_CRONO and PA2_EX_ADC which...
First and foremost, as of this point I know virtually nothing about these MC's but through this project, I'm hoping to learn. What I'd like to get some assistance on is just a few basic pointers and perhaps direction so that I'm not chasing my tail.T...
Hello STM32 Community,I’m currently in the research phase of a project where I’m using the STM32F103 "Blue Pill" with a SIM7600E module to send sensor data to an MQTT broker over 4G. I’ll be handling the communication via UART and AT commands.My ques...
