Need (Environmental) Prop65 Certificate
Need Prop65 Certificate for STM32F413RGT6511-USBLC6-2SC6
Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Need Prop65 Certificate for STM32F413RGT6511-USBLC6-2SC6
I have recently started learning STM32. Now I`m trying to send data from one Nukleo board to another via NRF24L01. I have already tried to use couple of libraries i found on the internet. But it didn`t work properly. I have read the documentation for...
Please could I have help identifying the component in the attached image to find a suitable replacement as it is shorted. Many thanks, Jazz.
We are looking to replace our use of M24M02-DR with M24M02E-F as it is available as TSSOP (the smaller CSP would also be useful but it seems no distributor is touching that at the moment) and cheaper (as I guess ST are promoting the replacement of th...
We want burn LINUX image to NAND flash locatted? We follow the guidence of STMC2. But what should we do next? We can't find any guidence for next step.
Hi,I downloaded stsw-rfsol001 then run SETUP.bat file to install STWPLLSim tool.When I open STWPLLSim tool the error show in firgure below, Please fix this problem ?Thank you very much.
Hi,I have an IC from ST where the case code is 464R. Please find the attached screenshot. Can you please help me figure out the IC's part number? I cannot find the correct information on internet. Thank you.Best regards,Adarsh
I am using STWPLLSim tool to simulate loop values for STW81200. After installing, when I start the program the following LIBRARY NOT FOUND error occurs:java.lang.UnsatisfiedLinkError: C:lProg ram Files (x86)1STMicroelectronicsISTWaLSim_v5.31Loaderlti...
Hi, I used eDesignSuite to base my Flyback Converter design with wide range input power supply and 60V-2A output. All the components look perfect to me, but the loop control with the proposed TL431 appears to be operating at about 60V. Looking in the...
Hello!Please tell me what the letter K means in the first line of the C56WK marking?My colleagues say that the ending can be either P or G. The Chinese supplier sent a photo before purchasing.We need 4 psc.Thank you!Best regards, Jack