Others: hardware and software

hi folks, i am using M58BW016FB flash memory as boot memory for MPC8358E processor in that i struct at writing a data into the memory . i am using freescale code warrior soft. for writing data into memory..

can you please help me how to write data into this flash and what are the commands and steps i have to follow....thank you.regards,venkat d

Does anyone have a copy of these files? They were mentioned in a post for an obsolete part, the ST90R158; but the links are broken. http://www.stmcu.com/mcdfiles/7241.pdf http://www.stmcu.com/mcdfiles/7620.pdf

Original post:https://community.st.com/s/question/0D50X00009Xkd3xSAB/its-possible-to-use-st90t158otp-as-rom-less-type-st90r158-help-me

Can you tell me if the following part numbers are obsolete?

M27C512-12F1LF351NThank you

Hi All, Does anybody used STUSB4500 A_B_SIDE signal for mux selecting TUSB542 IC. Regards, Vyshnav Krishnan

un38. 3 report for M4T28

Dears, during the air transportation,the Chinese customs ask the ​UN38. 3 report to confirm the safety of the M4T28 lithium battery. So we kindly ask the report. Thank you.​

How to enable GPGLL on Teseo-Liv3F module ?

I am working with Teseo-Liv3F to test NMEA0183 strings over BLSP UART 12 on my board. wanted to know how reset and wakeup are used to monitor UART transfers ?How can we enable GPGLL, GPVTG on the module to obtain NMEA strings?To test the antenna used...

i have an issue with st7flite29, where i am using Rlink programmer and the stvd7&stvp but getting this error : error on option byte complementary bytes , please reprogram option byte , also for the same issue i get the device is write protected .

Eeprom M93C86-WMN6 with µC TI TMS320F28069 R/W does not work reliably.

Hello team,I refer to a former posting from  MVoge, June 4, 2019 at 10:16 AMAs far as I can see from that thread, the timing question have bee cleared. Nevertheless, our problem persists (I'm continuing Marcel's work).This is, reading back values aft...

BUF420AW is not applicable, please help to find alternative models with higher current and voltage performance than BUF460A, thank you! !!

Is the MOSFET (STP85NF55L) reliability affected if the Vgs is near to the maximum specified in the datasheet?

My customer specifies a relation of 60% of the maximum Vgs for operation. My design is using 80% of the maximum Vgs. They are asking how this increase will affect the component reliability (failure mechanism, failure rate...).My design is eqquiped wi...