Others: hardware and software

STM8L sample example code to enter into Low power run mode and enter into Low power wait for event mode. - Thanks, Dhvanil

Hello, I have some question on PN:VIPER06XSTR. The attached photos for the parts of DC2119 and DC2142. X-ray photos have some different at lead frame. Is that normal and no affect the parts function? Thanks Manman

HELP with PWM measurement

Hello everyoneI am to use the Timer3 of STM8s105C6T in order to measure the duty cycle of a specific signal.But I also want the MCU to reset if this signal is disconnected.I am using PWMI feature of this timer meaning that rising edge and falling edg...

STM8s std peripheral

Hey!Could you please tell me how to have access to older versions of STM8s std peripheral libraries?Apparently, it's no longer available on st.com Thanks a lot!

I need hardware error feedback. Or also possible improvements in the design.

I'm using the theseo-liv3f module to make a GNSS board. In this project, I am only acquiring invalid positioning data, and I would like to know if there are any hardware errors to be corrected. I've already paid attention to the reset pin which is ac...

Can the device STM8AF6226TCY be replaced by the STM8AF6226TCSSSY?

Can the device STM8AF6226TCY be replaced by the STM8AF6226TCSSSY? Are they the same product? My customer wanted STM8AF6226TCY, but what we found was STM8AF6226TCSSSY. 

Reliability data for VNS7NV04PTR-E

We are using this low side driver in a battery controller and require reliability information in order to determine compliance with EN 1175

Dear all, I am new to NFC technology, so sorry for this newbie question. I have a board embedding an antenna and ST25TA02KB-D chip. I found a reader (PN532) so I would like to know if it is compatible for read/write operations with this chip. Thanks.