HiI am trying to configure SPI communication between L9963E and SPC574S64E3I referred the DSPI example in the latest SPC5StudioI could see the baud rate is configured to 1Mbps, 16kb and 26kb But as per the L9963E Spec the baud rate is either 333kbps ...
Hi,I am trying to communicate with BMS IC on our developed board and I donot see the communication happening with BMS IC despite of following all the instructions I have a L9963E BMS Eval board for reference,I have tapped out the SPI frames on the bu...
Hi, I just moved from stm32 with Cube IDE into AutoDevKit with an AEK-MCU-C4MLIT1 discovery board. I am so frustrated after a complete 8 hour spin and still no results. Why is AutoDevKit called an IDE when the Debugger is still external? I dont get i...
Hi,I tried to make an easy test of this board. when the button sw3 is pushed, LED 2 shall start blinking. Sadly it looks like my if statement equals always 0. Measuring the voltage on the testpin it looks like my MCU is sinking the complete voltage, ...
I am looking for the autodevkit community- is it here under Automotive? Or did it move somewhere else?
The avbove board comes with a blink example preloaded. I am looking for said example, any suggestions? The preinstalled suggestions seem to target more advanced programs
DearI installed AutoDevkitstudio yesterday.As I can see I should go to this web site"hightec-rt.com/en/" and get a license but in this site there is not any form that I fill it and get a license. Pleas help me more for getting license!. Thank you
Hi DearI try to build a test setup with AEK-AUD-D903V1 and AEK-MCU-C1MLIT1 follow the user manual um2719, when I modifed the "application.ld" document, an error was generatered. .sounddb : ALIGN(16) { __sounddb_start__ = .; *(.sou...
