AutoDevKit Ecosystem

Regarding OSAL Delay functions

Dear all,Good morning, I am facing issues with some functions in autodevkit.The functions osalThreadDelayMilliseconds() and osalThreadDelayMilliseconds() are blocking the entire execution.As the Autodevkit driver doesn't support the CANTP(response ta...

Resolved! Pin mapping change automatically even though any change under AVAS EVK

Hello, I have a trouble when I tried to change AMP I2C adreess on AVAS EVK which is based on AEK-MCU-C1MLIT1(https://www.st.com/en/solutions-reference-designs/sl-ssasf011101v1.html ) like the below. 1. In Allocation pin page, I just do "Delocation" a...

Checking for availability of CanTp

Hi all,Good Afternoon, I hope all are doing goodIn my project I am implementing diagnostics, so now I need CanTp for sending and receiving the data which is more than 8bytes. Now I am using SendCanMessage() API for transmitting the data and mcanconf_...

Software Reset API

Hello all,A very good afternoon, I hope you all are doing goodI am implementing Diagnostics in my project and in the during the implementation of service 11 I am facing the issue for software rest, I want to know which API performs the software reset...

Resolved! How to erase/write spcific NVM(MCU flash) part with Stellalink+AutoDevKit Studio on AVAS EVK?

Hello, As far as I known, ST released two kinds of AVAS EVK which one is based on AEK-MCU-C1MLIT1(https://www.st.com/en/solutions-reference-designs/sl-ssasf011101v1.html ) and another is based on AEK-AUD-C1D9031(https://www.st.com/en/evaluation-tools...

Resolved! Issue with open load detection in PLAY mode.

Hi all,I am facing issue with Open Load detection in PLAY mode and it is working fine in MUTE mode.I have flashed and tested the example base code from STM(Autodevkit), Open Load Detection is not working in PLAY mode in this code(Placed the example ...

the open load in PLAY is not detected in CAN message in AEK-AUD-C1D9031.

hi community, i had been working for a while on AEK-AUD-C1D9031 with CAN protocol and everything is working fine. but when i was working with open load of the speaker. in MUTE mode CAN message is working fine but in the PLAY mode the CAN me...

How to add extra memory to the AEK-AUDC1D9031 board

hi 1. on AEK-AUDC1D9031 there is SPC582B60E1 MCU with 1 Mb flash.2. i want to more wav files to play. but SPC582B60E1 is has only 1MB.3. so that i want to know how to integrate the extra memory to the AEK-AUDC1D9031 board.4. how to connect external ...

In "aek-AUD-C1D9031" - AVAS project the NOISE is high when I use PIT Timer Interrupt.

hi community, I am using the "Avas Compact - Test Application" example code which is provided in the AUTODEVKIT. I had extended that example code with PIT (the frequency is 1sec). after adding the PIT the WAV files are playing w...

want to know the CAN BUSOFF is implemented or not In "Avas Compact - Test Application".

hi community, I am using the "Avas Compact - Test Application" example code which is provided in the AUTODEVKIT. hear I enabled the CAN communication and it is working fine. but i want to know CAN BUSOFF is implemented or not in ...