HiI plan to interface the MT9M001 CMOS sensor (Parallel Interface) with STM32MP135F-DK, but the development board comes with the MIPI CSI2 Interface. Please guide me as to the process of integration and using OpenCv. Thanks
Dear,I'm starting with OP-TEE on STM32MP15x line. I bring-up the board as described here and built the optee_example_hello_world as described here. However, I got the error code below:TEEC_Opensession failed with code 0xffff0008 origin 0x3Checking th...
hi,I'm currently designing a custom board using the STM32MP157F MPU, and I'm referencing the schematic of the STM32MP157F-DK2 evaluation board. I'm stuck on identifying a specific component with a 0603 footprint. Is it a 0-ohm resistor? Additionally,...
I've been following the STM32MP15 Discovery kits - Starter Package tutorial to set up my STM32MP157D-DK1 board and am having trouble flashing the SD card via the CubeProgrammer CLI. It successfully loads partitions 0x01, 0x03, then the board disconne...
please explain the steps on how to boot the image in sd card for stm32mp157d-dk1 and also which os should i need to use for programming
Hello Community, we're trying to debug an STM32 image (kernel-version V6.1.28) on the M4 core using STLINK-V3SET debugger via STM32CubeIDE (V1.16.0) and getting the following error: Error in final launch sequence: Failed pre launch (s. attached scree...
Hello, We are evaluating the X-STM32MP-GNSS1 eval board on STM32MP-157F-DK2.The X-STM32MP-GNSS1 has Teseo-LIV3F GPS receiver on it, which does not support NAVIC.Since we want to test receiving signals from NAVIC specifically, can we replace the Teseo...
Dear Readers,I try to flash my board in Debian 6.1 on 64bit version in a VirtualBox.Whatever I doSTM32_Programmer_CLI -l usbalways fails.I have donesudo apt-get install libusb-1.0-0cd xyz /Drivers/rules sudo cp *.* /etc/udev/rules.d/I rebootet, but a...
Dear Sir, We are using stm32mp135f processor on our custom board. We want to interface flexible external memory controller bus with an external FPGA device. How this can be achieved? Are there any reference or example that you can provide? Is it poss...
Hi All,i am using STM32MP135-DK kit & i want to interface the ultrasonic sensor HC-SR04.from user space i have tried to make gpio toggle at 10uSec ON/OFF which will be trigger signal for sensor but what i observe in the trigger output pin is not tog...