I just saw this. It's from STM32MP157 discovery board.Notice that DQ9 is attached to E3.This schematic is the RAM DDR memory: They are connected correctly. The index of DQU2 is the 10:th index of DQ, also DQ10. But the naming of the net labels seems ...
I'm going to build my own computer by using STM32MP157 and install OpenSTLinux onto it. The powering for STM32MP157 can be done via USB-C connection, but that requires an USB-C charger of 5 volts.Can I skip that and only using a regular charger like ...
Hi, I'm please to share we pass extensive validation test of Zentel Japan 4Gb DDR3 A3T4GF40BBF-HP on STM32MP135F-DKregardsAlex
Hello, guys.My goal is highly consistent with this ticket:https://community.st.com/t5/stm32-mpus-products/cannot-get-spi-lcd-working-with-stm32mp157d-dk1-yocto/m-p/225522I hope to drive the LCD ili9341 based on STM32MP157F-DK2 but till now it has not...
16:15:34 : UR connection mode is defined with the HWrst reset mode16:15:34 : USB speed : High Speed (480MBit/s)16:15:34 : Manuf. ID : STMicroelectronics16:15:34 : Product ID : DFU in HS Mode @Device ID /0x500, @Revision ID /0x000016:15:34 : SN : 001B...
Hello, I've been attempting to get video output via the usb of the STM32MP157F-DK2 for some time now. From the research I've been doing, it seems as though there might be a possibility of it not being possible on certain hardware. Can anyone confirm ...
I am working with an STM32MP157d-dk1 board, but am trying to make my own MVP board running yocto on the STM32MP157 chip and have questions concerning the use of the debug console.I believe the debugging console for the dev board runs via uart4, and i...
All,I am currently working on a project using the STM32MP157C-DK2 Board.I am implementing the intra-processor communication using the OpenAMP lib.I am using the STM32CubeMX tool to pre-generate the project for the cortex-M.However, I can't find the s...
Hello! I'm trying to figure out if the M4 has the ability to put the A7 to sleep but haven't quite figured out how to get the info from the M4 to the A7 at this time. I've been going through the forums and the Ecosystem V5 page and haven't had much...
I realize this is probably a pretty basic question but I haven't found a way to have the M4 portion of the firmware startup when the STM32MP1 is powered up. I'm currently using an STM32MP157D-DK1 board, if that helps. I was able to debug the code of...