Hi , i have the custom board of (STM32mp157F-dk2), all the things are same but the ST-Link channel removed and many thing changes has done , there is added JTAG pin in place of ST-link port , so in Openstlinux distribution package any modification s...
I have carefully followed the getting started guide for the STM32MP157x-EV1 board. All the steps I took were successful until I reached the "Execute basic commands" section where I am instructed to run the following command:ls /dev/ttyACM*The expecte...
Hello. I am desperately trying to connect a St Link (V2 and V3) to a news card. The chip is an STM32MP135. This component is equipped with lines allowing connection via the SWD protocol. However, the STM is not recognised. How can I hope to contact t...
Hello! I'm trying to figure out if the M4 has the ability to put the A7 to sleep but haven't quite figured out how to get the info from the M4 to the A7 at this time. I've been going through the forums and the Ecosystem V5 page and haven't had much...
I realize this is probably a pretty basic question but I haven't found a way to have the M4 portion of the firmware startup when the STM32MP1 is powered up. I'm currently using an STM32MP157D-DK1 board, if that helps. I was able to debug the code of...
Not sure if this is the right place to write this, but I cannot help to write:- STLINK-V3PWR is a great tool.- I wish it had an external power input other than USB-C. It may be common in some computer setups, but powered USB ports might be challengin...
Hello,The QC for STLINK-V3PWR assembled in France seems to be very bad. I received a unit that doesn't work out of the box (when USB is connected the status leds stay off, AUX power outputs 3.3V, host computer doesn't detect V3PWR).The same host comp...
Hi,When I power on my STM32MP157A-DK1 board, ST-LINK LED (LD4) is always red. On my Linux system when I connect the board through ST-LINK micro usb port (CN11), it is only detected as 'STM32 Virtual ComPort', and not detected as StLink device. And wh...
From instructions, I opened two console: Console 1: openocd -f board/stm32mp15x_dk2.cfg This looks good as output: ``` ... Info : stm32mp15x.cm4: Cortex-M4 r0p1 processor detected Info : stm32mp15x.cm4: target has 6 breakpoints, 4 watchpoints Info ...